After finishing the double pockets, it was time to make some more pockets for the vest. These go above the other pockets.
The first thing was to make a pattern, and I had no idea how to do that, because the pockets needed folds. However, that's what the teachers are for. It turned out to be quite simple, you just need to know what to do. In this case, it was the same thing we did when making the patterns for the bell-shaped skirt.
You make a pattern for a flat pocket, cut it as shown in the picture above, and then spread out the bottom ends of the outer parts a bit. In this case, there is 1 cm added to both corners. Then you glue the pieces in place and draw the seam allowances around the pattern created this way. When sewing, you just make folds that remove 1 cm from both corners, and the result is a pocket with straight vertical sides.
The order of sewing is: sewing and stitching the folds in the corner, hemming the upper edge, ironing the seam allowances in the sides and bottom edge, and stitching the pocket in place. With a single color fabric, you'd use either the hem or front middle to get the pockets straight, but in this case, I used the upper edge of the lower pockets, because the pictures needed to be horizontally straight.
So now the vest has all of the outside pockets. The next step is to make the lining and the inside pocket that will be sewn into it. I'm currently in the middle of making a sample of the inside pocket, because getting the zipper in place properly is a bit tricky. Best to practice first before touching the actual lining.
No comments:
Post a Comment